S&W M&P 22LR replacement captured recoil guide rod assembly complete with buffer and recoil spring not for the M&P Compact

Home > Gun Parts >

Smith & Wesson M&P-22 Captured Guide Rod Assembly

M&P 22 | S&W M&P | guide rod | recoil spring | recoil buffer | captured guiderod | replacement recoil | M&P22 | recoil spring | recoil guide rod | 22lrupgrades | recoil guide rod

Alternative Views:

Constructed of stainless steel, our guide rod allows for easier assembly of the Smith & Wesson M&P22 pistol (Does not fit the M&P22 COMPACT). The captured guide rod assembly uses a hex screw and a stainless steel Bushing at the end of the rod to "capture" the recoil spring. The guide rod can be used with both factory strength and reduced power springs offered HERE It is recommended to use a small amount of thread locker on the screw to keep it from backing out over time.
Captured Guide Rod Assembly comes with

Stainless Steel Guide Rod
Stainless Steel Bushing
Hex Screw
Hex Wrench
Polymer Recoil Buffer
Factory Strength Recoil Spring

*THIS ONLY WORKS ON THE FULL SIZED M&P22 AND NOT THE COMPACT

MSRP: $34.99

Our Price: $29.95

Savings: $5.04

Shipping: Usually Ships in 1 to 2 Business Days
Part #: 101-SSGR-MP22

Qty:

Installation Instructions

RESTRICTIONS

1) Turn down the takedown catch 90 degrees and pull out.

2) Pull back the slide all the way to the rear and pull up the back side of the slide.

3) While holding the rear section of the slide up allow the side to move forward and come off the frame.

4) Remove the old recoil spring, Guide Rod and Buffer.

5) Slide over end of guide rod the Polymer recoil buffer, recoil spring, then Stainless Steel washer.

6) Compress the spring and Stainless Steel washer and install hex screw. NOTE: a tiny amount of thread locker is recommended.

7) Install the new Captured Guide Rod Assembly and reverse steps 1-3.