Home > AR-15 Parts >

AR15 / AR10 Mil-Spec Trigger Adjustment Grip Screw Kit - 2pk

AR15 Mil-Spec Trigger Adjustment Grip Screw Kit | ar15triggerjob | ar15 adjustment screw | trigger adjustment screw | trigger adjuster | trigger adjusters | pre-travel | creep MSR
 
Alternative Views:


This ingenious screw design replaces the milspec factory grip screw to remove the trigger creep and travel from factory mil-spec triggers in the AR15 and AR10 rifles. The kit comes with two (2) grip screws with internal adjustment screws, two (2) lock washers and one (1) hex wrench for adjustment of the internal screw. The adjustment screw allows for tweaking the hammer and trigger engagement points to clean up the GI trigger and give you a cleaner trigger pull for increased accuracy.

International Orders Click HERE

MSRP: $32.95
Our Price: $24.95
Savings: $8.00


Shipping: Usually Ships in 1 to 2 Business Days
Part #: AR15-ADJ-SCREW-KIT-2PK
Qty:

Installation Instructions RESTRICTIONS
 
1. The internal set screw comes with thread locker pre-applied but for best results remove the internal screw and apply additional thread locker and re install the set screw inside the large screw. Make sure to screw down the internal screw all the way in so that the tip just protrudes.

2. Remove the factory grip screw and lock washer from the grip of your rifle. Mind the spring and detent for the safety as they may bounce out if you remove the grip completely.

3. With the hammer cocked and the gun on safe, insert the Trigger Adjustment Screw into the grip and tighten the large screw with a 3/16” hex wrench until he pistol grip is secure.

4. Using the included hex wrench, finger tighten the internal screw inside the 3/16” screw until the it stops. DO NOT OVER TIGHTEN. Backout the internal screw 1/4 turn at a time until the safety lever can by actuated. Verify that the trigger, disconnector, hammer and safety function correctly. Let your additional thread locker dry before putting your rifle to use.

AR15 Trigger Adjustment Grip Screw Install Instructions
The Late Boyscout Video Review

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 1 Write a review »

  0 of 0 people found the following review helpful:
 
5 of 5 Trigger Adjustment Grip Screw February 12, 2021
Reviewer: Dwight Gonzales from Fayetteville, AR United States  
This product exactly what it says it will do.  Simply install your grip, and then tighten the adjuster until all creep is gone and the safety switches on/off.  Boom, no more creep!

Was this review helpful to you?