Home > Gun Parts >

Sig / GSG 1911 22lr Silver Magwell with Silver Arched Mainspring Housing

GSG / Sig Sauer 1911-22 Magwell with Arched Mainspring housing - Silver


 
Alternative Views:


Our magwell comes with an aluminum mainspring housing and mainspring cap pin. The magwell and mainspring housing are constructed of aluminum and machined to close tolerances for a clean fit. Some fitting may be required. Please note that the included mainspring cap pin is required if you are replacing the factory mainspring housing on the GSG or Sig Sauer pistols.


NOTE: IT MAY BE NECESSARY TO REMOVE SOME MATERIAL ON THE ALUMINUM MAINSPRING HOUSING IN ORDER TO GET IT INSTALLED (FITTED) INTO THE PISTOL GRIP.

International Orders Click HERE

MSRP: $89.95
Our Price: $69.95
Savings: $20.00


Shipping: Usually Ships in 1 to 2 Business Days
Part #: GSG-1911-22-SLVR-MW-SLVR-A-MSH
Qty:

Installation Instructions RESTRICTIONS
 
1. Remove factory mainspring housing.

2. Check the fit of the new mainspring housing in the pistol. Some fitting may be required.

3. Push out the mainspring cap pin. If your are replacing the factory mainspring housing you will not use this factory cap pin. Use the mainspring cap pin provided instead.

4. Remove the mainspring cap, mainspring, and mainspring housing pin retainer.

5. Insert the factory mainspring housing pin retainer, mainspring, mainspring cap, into the included light weight aluminum main spring housing.

6. Compress all parts listed in step 5, and while compressed insert the included mainspring cap pin into the mainspring housing.

7. With the pistol hammer down, Insert the assembled mainspring housing into the pistol.

8. Insert the factory mainspring housing pin into the frame to secure the mainspring housing.

9. Verify that the grip safety functions properly with the new mainspring housing.

10. Screw into place the magwell with the included 8-32 screw using a 5/64" hex wrench. Tighten at approximately 15 inch-lbs

NOTE: IT MAY BE NECESSARY TO REMOVE SOME MATERIAL ON THE ALUMINUM MAINSPRING HOUSING IN ORDER TO GET IT INSTALLED (FITTED) INTO THE PISTOL GRIP.


Mainspring Housing Install

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 1 Write a review »

  0 of 0 people found the following review helpful:
 
5 of 5 Looks and fits great! Be patient in fitting!! August 15, 2020
Reviewer: James Dietz from Santa Ana , CA United States  
The instructions that came with the housing note you may have to remove some material from the top ledge of the new housing. I did not need to. However, the ears that slide into the frame did need to be reduced in size.

Use a marker on the sides of the housing so that when you insert it in the frame you will be able to see where it is rubbing. Mine, initially, barely entered. So, using a fine file and 1500 grip sandpaper, I started taking the tiniest bit of material off, being careful to use smooth, even strokes on the ears. And, I did just a few passes at a time, marked the housing again, reinserted and removed to see where it was now rubbing.

Each time I did this, the housing would go in just a bit farther, until it eventually was in. All this took maybe 30 minutes, as I was removing very little metal each time. The fit is now snug, much better than the original.

A plus of the new housing that the magazine safety which was inside the old housing will be gone forever!!

Was this review helpful to you?