Home > Springs > GSG 1911 22 >

Sig Sauer / GSG 1911 Plunger Spring

411.20.09.1 | Sig Sauer 1911-22 | GSG 1911-22 | plunger spring for 1911 | Factory plunger Spring | 1911-22 plunger spring | 1911 plunger spring | 922 plunger spring | 1911 spring | 1911springs, 22lrupgrades

Replace your worn out or lost plunger spring. This plunger spring is a replacement spring for the GSG and Sig Sauer 1911-22 pistols. The factory part number for this spring is 411.20.09.1 (part #38 in the exploded diagram). This spring is not for the centerfire 1911 pistols but is specifically made for the 22LR. It is shorter than the typical 45ACP type 1911.

International Orders Click HERE

Our Price: $3.95

Shipping: Usually Ships in 1 to 2 Business Days
Part #: 102-0FPS-0GSG

Installation Instructions RESTRICTIONS

1) Verify pistol is empty

2) Cock hammer

3) Put pistol on safe and slowly wiggle safety up and down while pulling out of the frame

3) Insert new plunger spring and Safety Lever Plunger

4) Compress spring and plunger and insert safety into frame in the "safe" position
NOTE: It may be necessary to remove the slide in order to "wiggle" the safety up and down enough to remove and install. But the safety will be inserted and removed with it in the upward position (Safe Position)

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 1 Write a review »

  0 of 0 people found the following review helpful:
5 of 5 Good source June 19, 2020
Reviewer: Carroll V from Round Rock, TX United States  
Great source for GSG parts.

Was this review helpful to you?