Home > Gun Parts > Colt 1911-22 >

Colt 1911 22LR Replacement Safety Lever Plunger

Colt Walther Umarex 1911 22 Replacement Plunger | 517.200.18.0 | safety lever plunger | lost | lost plunger | 1911 plunger | 22lrupgrades | 1911-22 plunger | colt plunger | walther plunger


 
Alternative Views:


Replace your worn out or lost safety lever plunger. This plunger is a replacement for the Colt 1911-22 pistols made by Walther / Umarex. This plunger only fits the Colt 1911-22 and Umarex pistols made by Walther Arms. It will not fit centerfire 1911 or 2011 handguns. The factory part number for this spring is 517.200.18.0 (part #29 in the exploded diagram). If yours shot across the room while disassembling your pistol, never to be seen again, this part is for you.

MSRP: $8.95
Our Price: $4.95
Savings: $4.00

Shipping: Usually Ships in 1 to 2 Business Days
Part #: 900-0SLP-COLT
Qty:

Installation Instructions RESTRICTIONS
 

1) Verify pistol is empty

2) Cock hammer

3) Put pistol on safe and slowly wiggle safety up and down while pulling out of the frame

3) Insert new safety plunger lever

4) Compress spring and plunger and insert safety into frame in the "safe" position
NOTE: It may be necessary to remove the slide in order to "wiggle" the safety up and down enough to remove and install. But the safety will be inserted and removed with it in the upward position (Safe Position)


Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 3 Write a review »

  0 of 0 people found the following review helpful:
 
5 of 5 July 19, 2020
Reviewer: martin perkins from ignacio, CO United States  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 May 10, 2020
Reviewer: Scott from Mukwonago , WI United States  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 May 8, 2020
Reviewer: Bruce Hanson from Argyle, TX United States  
perfect

Was this review helpful to you?