Home > AR-15 Parts >

AR15 Single Point Attachment Sling Plate
ar15 ambi sling attachment | ar-15 sling | ar15 sling | ambidextrous sling | ambidextrous single point sling | ar15 m16, ar-16


 
Alternative Views:


AR15 ambidextrous center verticle loop, no bind 180 degree sling adapter end plate is constructed of all steel for strength and durability. It easily installs in minutes and will replace the original factory reciever end plate. This will allow you to attach a sling for a 180 degree range of motion to smoothly transition from one shoulder to the other and avoid snagging on your clothes or other gear while shooting. It is also great for easy tactical carry when not in use. No gunsmithing is required.

  • Length: 2.0"
  • Weight: 0.7 oz.
  • Material: Steel

International Orders Click HERE

MSRP: $10.99
Our Price: $8.99
Savings: $2.00

Shipping: Usually Ships in 1 to 2 Business Days
Part #: MAR033
Qty:

Installation Instructions RESTRICTIONS
 
1) Verify weapon is unloaded
2) Remove the lower from the upper
3) Loosen castle nut and remove buffer tube (be mindful of detent spring for the rear takedown pin)
4) Remove the end plate and replace it with single point sling attachment end plate
5) Reassemble in reverse order

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 4 Write a review »

  0 of 0 people found the following review helpful:
 
5 of 5 August 4, 2021
Reviewer: Donald Evans from ,  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 July 13, 2021
Reviewer: Ryan from ,  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 July 1, 2021
Reviewer: Anonymous Person  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Great for what I'm using it for. June 2, 2021
Reviewer: Scott Jackson from Greenville, TX United States  
So i got this a one piece of my AR15 22lr Han Solo blaster build. The sling point loop on the back is large and sturdy. Making the gun, which has no buffer tube, look like it has a hammer on the back side. A little taping, some wire wheel work,and it will look even more like a hammer. Adding that extra little touch to my blaster.
 As for what it intended for, its sturdy, and well made. It should work fine, although I could see some problems fully collapsing the stock with it on.

Was this review helpful to you?