Return to Dillon Powder Bar Finger Adjustment Assembly

Sort By:: Most Helpful Newest Rating: High to Low Rating: Low to High	Page of 11

0 of 0 people found the following review helpful:

Disappointed August 1, 2024 Reviewer: Herbert Seegers from Eustis, FL United States   I purchased this to make powder adjustments on my Dillon RL550C easier.  First off, it was a serious struggle to assemble the washer (provided) and spring washer, which ended up being totally collapsed, thus eliminating any spring action.  My targeted weight for my pistol load was 3.9 grains of CFE Pistol powder, the lowest amount I was able to dispense was 5.4 grains.  I removed the Taylor Tactical Finger Adjustment Dial and reinstalled the original Dillon adjustment screw and was able to adjust down to 2.1 grains, being able to load my desired weight of 3.9 grains.  I emailed Taylor Tactical and did not recieve a reply.  I would NOT recommend this product. Was this review helpful to you?

0 of 0 people found the following review helpful:

Finger adjustment assembly August 1, 2024 Reviewer: Robert Lochner from Brentwood, CA United States   works perfectly - nice improvement over stock screw Was this review helpful to you?

0 of 0 people found the following review helpful:

Powder bar adjuster May 27, 2024 Reviewer: Bill Bowers from Colorado Springs, CO United States   Excellent product Was this review helpful to you?

0 of 0 people found the following review helpful:

Dillon powder bar May 13, 2024 Reviewer: Garland Stewart from Fremont, NE United States   Works good Was this review helpful to you?

0 of 0 people found the following review helpful:

order April 24, 2024 Reviewer: Thomas Powell from Marquand, MO United States   Easy to order and received in good time. Was this review helpful to you?

0 of 0 people found the following review helpful:

Powder adjustment made easier March 20, 2024 Reviewer: Davis from Upper Marlboro, MD United States   Installation on an older powder measure was a little more difficult and took a lot of elbow grease! But new on new fit in to place super easy! This item definitely made my reloading / measuring powder easier. Was this review helpful to you?

0 of 0 people found the following review helpful:

Finger adjustment March 18, 2024 Reviewer: Greg P. from MA   Just purchased a new Dillon RL550C and started collecting small things to make it easier to enjoy.  I saw the powder adjustment knob and thought it  would be easier to dial in a measurement with it instead of using the wrench. I haven't had a chance to set things up yet because I had my rotator cuff done and can't use my arm yet so I really can't give a review but I'm guessing it will be easier to get a fine adjustment with it over the wrench. Was this review helpful to you?

0 of 0 people found the following review helpful:

Worked great! February 26, 2024 Reviewer: Taylor Capers from Sedalia, MO United States   As described, definitely an easier way to gradually adjust powder. Was this review helpful to you?

0 of 0 people found the following review helpful:

Dillon powder adjustment January 22, 2024 Reviewer: BC from Rocky Point, NC United States   This is the second  Dillon powder adjustment screw/knob I have purchased and as with the first, adjustments are much easier than with the standard Dillon , which requires a wrench. Well worth the cost. Was this review helpful to you?

0 of 0 people found the following review helpful:

awesome product December 28, 2023 Reviewer: ROBERT OVERSTREET from Columbia, MO United States   i put them on every dillion powder bar i own before i assemble the die set Was this review helpful to you?