Home > Springs >

Walther PPQ 22 Factory Replacement Recoil Spring
Walther PPQ | Walther PPQ22 | PPQ22 | PPQ-22 | Walther | Replacement recoil Spring | nictaylor00 upgrade | 22lrupgrades | recoil spring | replacement spring


 
Alternative Views:


Having feeding issues? Replace your worn out recoil spring and improve performance. This recoil spring is a direct replacement part for your Walther PPQ 22 long rifle pistol. Keep in mind this is a new spring and therefore it has not yet "set" or been compressed yet. So the first time you install it may seem too long but it is the correct length and will become shorter after being compressed.

MSRP: $8.95
Our Price: $5.25
Sale Price: $3.25
Savings: $5.70

Shipping: Usually Ships in 1 to 2 Business Days
Part #: PPQ-RECOIL-SPRING
Qty:

Installation Instructions RESTRICTIONS
 
1) Pull down the takedown catch

2) pull back the slide all the way to the rear and pull up the back side of the slide.

3) While holding the rear section of the slide up allow the side to move forward and come off the frame.

4) Remove the old recoil spring.

5) Install the new recoil spring and reverse steps 1-4. Using a rod the diameter of the internal diameter of the spring will aid in guiding the spring onto the guide rod while assembling the gun. (See the photos below).

Share your knowledge of this product. Be the first to write a review »