Home > AR-15 Parts >

AR15 Mil-Spec Trigger Adjustment Grip Screw
AR15 Mil-Spec Trigger Adjustment Grip Screw


 
Alternative Views:


This ingenious screw design replaces the milspec factory grip screw to remove the trigger creep and travel from factory mil-spec triggers in the AR15 rifle. The grip screw has a smaller an internal adjustment screw. The adjustment screw allows for tweaking the hammer and trigger engagement points to clean up the GI trigger and give you a cleaner trigger pull for increased accuracy.

NOTE: This is the adjustment screw ONLY. You will need a 5/64" Hex Wrench long enough to reach up inside the AR pistol grip in order to adjust the internal screw. We offer one HERE

MSRP: $12.95
Our Price: $8.95
Savings: $4.00

Shipping: Usually Ships in 1 to 2 Business Days
Part #: AR15-ADJ-SCREW
Qty:

Installation Instructions RESTRICTIONS
 

1. The internal set screw comes with thread locker pre-applied but for best results remove the internal screw and apply additional thread locker and re install the set screw inside the large screw. Make sure to screw down the internal screw all the way in so that the tip just protrudes.

2. Remove the factory grip screw and lock washer from the grip of your rifle. Mind the spring and detent for the safety as they may bounce out if you remove the grip completely.

3. With the hammer cocked and the gun on safe, insert the Trigger Adjustment Screw into the grip and tighten the large screw with a 3/16” hex wrench until he pistol grip is secure.

4. Using a 5/64" hex wrench, finger tighten the internal screw inside the 3/16” screw until the it stops. DO NOT OVER TIGHTEN. Backout the internal screw 1/4 turn at a time until the safety lever can by actuated. Verify that the trigger, disconnector, hammer and safety function correctly. Let your additional thread locker dry before putting your rifle to use.

AR15 Trigger Adjustment Grip Screw Install Instructions
The Late Boyscout Video Review

Share your knowledge of this product. Be the first to write a review »