Home > AR-15 Parts >

AR15 / AR10 Skeletonized Trigger
AR15 low cost trigger job | Flat AR trigger | Mil-Spec | AR-15 | trigger job | drop in

Alternative Views:

Skeletonized flat trigger for AR type rifles and variants. The Bullmoose flat trigger is a drop in replacement trigger that works with milspec fire control components and is designed to lighten your trigger pull for a precision rifle feel at a fraction of the cost. The flat trigger surface provides an even and consistent trigger pull where ever the operators finger is placed. 4.5-5.5lb trigger pull with milspec springs. Use in conjunction with the included NicTaylor00 reduced powder hammer and trigger springs for an even lighter trigger pull (sold HERE). Both trigger and spring can be installed in a matter of minutes.


Application: The Reduced Power Hammer Spring is intended for competition and recreational use only and should not be installed in any rifle used for defense or duty applications. By reducing the spring tension, the introduction of light strikes or failures to fire due to the lack of primer detonation may occur.

MSRP: $29.98
Our Price: $26.98
Savings: $3.00

Shipping: Usually Ships in 1 to 2 Business Days

Installation Instructions RESTRICTIONS
All you need is a punch or hex wrench small enough in diameter to push out the hammer and trigger pins located in your AR15 lower. Once you push out the hammer pin, the hammer and spring can be removed from the lower. Take note of the orientation of the spring as it sits on the hammer so that you can install the new spring in the same position. Simply pull the spring off the hammer by grabbing one of the coils and pull. Install the NicTaylor00 Reduced Power Hammer Spring onto the hammer and set it aside.

Remove the selector by loosening or removing the grip screw. This will lessen the tension on the selector detent spring and allow the selector to be removed. Push out the trigger pin and lift out the trigger and trigger spring from the lower. Take note of the trigger spring and install the NicTaylor00 Reduced Power Trigger Spring onto the Bull Moose Tactical Skeletonized trigger in the same orientation. Reinsert the trigger / spring and disconnector into the lower and install the trigger pin. Next reinsert the selector making sure the detent is in place, then tighten the grip screw.

Reinsert the hammer/spring into the lower while pushing the hammer pin back into place through the lower. Be careful not to force the pin as you attempt to push it through the lower. Remember the lower is aluminum and the pin is steel, so forcibly hitting the pin or pushing harshly it may cause damage to your lower if all is not lined up perfectly.

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 3 Write a review »

  0 of 0 people found the following review helpful:
5 of 5 Skeleton trigger March 31, 2020
Reviewer: Charles Lea from Starkville, MS United States  
For the price it really sets the gun apart from others. For perfect in a MIL-Spec lower, even if you have a flat trigger guard! Way better than paying $150 for a drop in trigger! Feels great even with standard springs

Was this review helpful to you?

  0 of 0 people found the following review helpful:
5 of 5 Skeletonized flat AR trigger March 26, 2020
Reviewer: Heath Parker from Boston, GA United States  
This is the second one I have bought. The first went in a 15/22, and this one went into a Extar EP9.  Both were shipped very fast, were packaged great.
Crisp break, and good machining surfaces.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
5 of 5 Hard to find trigger March 23, 2020
Reviewer: bob chiella from Rochester, NY United States  
great drop in straight trigger, tolerance very good , for a very hard to find item priced good 5 star

Was this review helpful to you?