Home > Magazine Upgrades >

Colt 1911 22lr Black Magwell with Black Flat Mainspring Housing
Colt 1911 22lr magwell and main spring housing msh | 1911 MSH | 1911 magwell | railgun magwell | 1911-22 parts | 22lrupgrades | Colt railgun parts


 
Alternative Views:


The Colt 1911-22 pistols have many interchangeable parts with standard 45 ACP pistols. However, the magwell is not one of them. The factory 22lr magazine has a wider basepad than your typical 45ACP single stack mag and therefore all after market magwells designed for 1911's will not fit the Colt 1911-22 pistol made by Walther / Umarex. Our magwell is designed specifically for the Colt 1911 22LR pistols so that factory magazines and magazines equipped with NicTaylor00 / Shockbottle basepads and magazine upgrades will fit in the gun.

Our magwell comes with an aluminum main spring housing, main spring housing pin retainer, main spring cap, and mainspring cap retainer pin. Both the magwell and main spring housing are constructed of anodized aluminum and machined to close tolerances for a clean fit. Some fitting may be required.

MSRP: $89.95
Our Price: $69.95
Savings: $20.00

Quantity in Stock:10
Shipping: Usually Ships in 1 to 2 Business Days
Part #: COLT-1911-22-BLK-MW-BLK-F-MSH
Qty:

Installation Instructions RESTRICTIONS
 
1. Remove factory mainspring housing.

2. Check the fit of the new mainspring housing in the pistol. Some fitting may be required.

3. Push out roll pin used to retain the factory mainspring in the factory mainspring housing.

4. Retain the mainspring that is in your pistol.

5. Insert the included mainspring housing pin retainer, your mainspring and the included mainspring cap into the light weight aluminum mainspring housing.

6. Compress all parts listed in step 5, and while compressed insert the included mainspring cap retainer pin into the mainspring housing.

7. With the pistol hammer down, Insert the assembled mainspring housing into the pistol.

8. Insert the factory mainspring housing pin into the frame to secure the main spring housing.

9. Verify that the grip safety functions properly with the new main spring housing.

10. Screw into place the magwell with the included 8-32 screw using a 5/64" hex wrench. Tighten at approximately 15 inch-lbs

NOTE: IT MAY BE NECESSARY TO REMOVE SOME MATERIAL ON THE ALUMINUM MAINSPRING HOUSING IN ORDER TO GET IT INSTALLED (FITTED) INTO THE PISTOL GRIP.

Colt 1911-22 LR Magwell Installation Instructions

Share your knowledge of this product. Be the first to write a review »